beverley
from
United Kingdom
asks
I bought two smart door chime cable free wirless plug in door chimes, only want to use one of the bells but pair the plug in so can use in different rooms, how do i do this ?
Electrical World Replies:
|
Hello, thanks for the question. To pair the push buttons and the door chime, press and hold the pairing button for 5 seconds until you hear a double beep and then release, then press the bell push until you hear a single beep and then release. Wait for around 20 seconds until you hear another double beep.
|
Richard
from
Ireland
asks
Hi,can I take it from previous answer that I can pair two chimes to one bell push
Electrical World Replies:
|
Hello, thanks for the question. Yes, you can pair multiple chimes to one bell push.
|
Daniel
from
United Kingdom
asks
I don’t no how to open the back off the button what u put out side so it will ring can some one help me please
Electrical World Replies:
|
Hi - if installing the push button, the lithium battery is already installed, it is ready to use by pulling out the plastic strip. If you're replacing the batteries, remove the back of the case by pushing the tab on the bottom with a small, flat screwdriver. Remove the locking screw from the battery fastener, insert 1 x 3 volt lithium battery into the battery compartment ensuring the battery polarity matches the internal markings. Snap the front cover of the push button back on. If you are unsure of any of the components, there is a diagram in the instruction manual. We hope this helps.
|
Elizabeth
from
Gibraltar
asks
Can i use one bell with 2 chimes
Electrical World Replies:
|
Hello
yes this can be used 1 bell push to 2 chimes
thanks
|
Eli Barnett
from
United Kingdom
asks
Can I purchase an additional receiver?
Electrical World Replies:
|
Hello
I am afraid we do not sell separate receivers for this product
Thanks
|
Martin
from
United Kingdom
asks
Unable to pair, I hold the button for 5 seconds and this does activate a double beep, however holding in the bell push does not initiate a single beep (although the light is red on the button.
Any ideas?
Electrical World Replies:
|
Hello
Please contact our customer service team
Thanks
|
David
from
United Kingdom
asks
How do I change to chime on this doorbell. It was ok to start with but batteries ran out and I now get default chime, how do I choose the one I want?
Electrical World Replies:
|
Hello, This product comes with an instruction leaflet to show you how to reset the doorbell.
Please see the instructions on the listing. Thanks
|